Local Philips Medical Systems representative, or by the manufacturer. Intended Use of this Service Manual This Philips product is intended to be operated only in accordance with the safety procedures and operating instructions provided in the Service Manual, and in accordance with the purposes for which it was designed. Installation, use, and oper. For the respiratory measurement (Resp), the monitor measures the thoracic impedance between two ECG electrodes on the patient’s chest. Changes in the impedance due to thoracic movement produce the Resp waveform on the monitor screen. The monitor counts the waveform cycles to calculate the respiration rate (RR). Configuration choices. For specific information on using the Philips Telemetry System or the Philips IntelliVue Telemetry System, please refer to your appropriate telemetry system Instructions for Use manual. The on-line Information Center Help provides instructions for completing basic tasks and troubleshooting problems.
- Cardiac Telemetry Monitor
- Philips Telemetry System
- Philips Intellivue Telemetry Mx40 Monitor
- Telemetry Monitor Technician
- Philips M2601A S03 (EASI) ECG Telemetry Transmitter
Refurbished
2.00 LBS
Ships in 24 hours
Calculated at checkout
Product Description
The Philips M2601A Telemetry system transmitter sends continuous ECG and SpO2 measurements to the IntelliVue Information Center, where the measurements are captured, analyzed, displayed, and stored.
The basic setup comes with 3-lead or 5-lead capability. The ECG-only transmitter is particularly light and comfortable for patients. Upgraded transmitters combine standard and EASI derived 12-lead ECG monitoring on a single device, run on easily replaceable AA batteries, and provide audio feedback for many tasks, including “power on” and SpO2 spot check.
The basic setup comes with 3-lead or 5-lead capability. The ECG-only transmitter is particularly light and comfortable for patients. Upgraded transmitters combine standard and EASI derived 12-lead ECG monitoring on a single device, run on easily replaceable AA batteries, and provide audio feedback for many tasks, including “power on” and SpO2 spot check.
Features:
- Frequency of 460-480 MHz or 608-614 MHz WMTS
- Lightweight—less than ½ lb.
- Standard ECG configuration with 3- or 5-lead capability
- EASI ECG configuration used for transmitters that work with central stations that are capable of converting a 5-wire lead set signal to 12 lead analysis by having EASI version software installed at the central station.
- SpO2 configuration used for transmitters that are used with SpO2 sensors.
Philips 5 Lead Dual ECG Leadwire - Snap ($55)
Philips 5 Lead Single Pin w/Tele Shield ECG Leadwires - Grabber ($95)
Cardiac Telemetry Monitor
Add SpO2 Probe (Only Available with S02 Model):
Warranty Information
![Philips Telemetry Monitor Manual Philips Telemetry Monitor Manual](/uploads/1/1/9/5/119591091/822216880.png)
Find Similar Products by Category
Product Reviews
Philips Telemetry System
Please enable JavaScript to view the comments powered by Disqus.
![Philips telemetry monitor manual download Philips telemetry monitor manual download](/uploads/1/1/9/5/119591091/647520662.jpg)